|
The wish to save adhesive associates with the
wish to reduce the water proportion in the adhesive. This would
favour behind a reduction of the production costs also the
curing time and the flatness. With the today’s coating systems
it is often not possible to reduce the adhesive volume
proportion and therefore the adhesive mass application to the
necessary minimum. Older systems are still concerned frequently.
To reach this limit a filling compound have to be found which
meets the above requests and which is also reasonably priced.
Air represents an ideal “filling compound”.
With the
MÜGROMIX(K)+
the air will be mixed product-protective through a dynamic low
shear mixing head into the adhesive compound. Therefore the
coating system can applicate the same volume mass-reduced on the
product which have to be applied. Through the easy adjustment
possibility of the foam weight on the
MÜGROMIX(K)+
the adhesive proportion can easy be reduced to the needed
minimum and therefore adapt to the product which have to be
applied and the used adhesive.
Depending on the application
case adhesive of 15-40% will be saved and the humidity content
will be reduced up to 10% relative air humidity. Thereby the
flatness will be improved, from which the successor processes (print,
cut, punch) profits seriously. By shortening of the curing time
the drying costs can be reduced and/or the production speed can
be increased. With the
MÜGROMIX(K)+
adhesives as PVA, PVAC, latex, water glass etc. can be foamed
up. All well-known manufacturers of adhesives currently offers
foamable adhesives. |
